![]() If you’ve done everything you can to minimize physicals hazards, your next step in preventing slips, trips and falls is clear: you need to address human factors.ĭiscover how to address human factors in your slips, trips and falls prevention efforts by downloading Solving Slips, Trips and Falls Once and For All: A guide to addressing the physical and human factors in slips, trips and falls for free. But no matter how effective the rest of your safety program is, your employees have a higher risk of injury due to a slip, trip or fall when they’re in one of these four states. When we’re rushing, frustrated, tired or complacent we tend to make errors and decisions that increase the chance of injury. Slips, trips, and falls are some of the most common types of workplace injuries and are the top reason for worker’s compensation claims. The truth is that many slips, trips and falls are caused or made worse by a person’s state of mind. Fall hazards should always be your first priority, but you can’t eliminate injuries caused by slips, trips and falls by only dealing with physical factors. Most safety programs focus on the physical hazards of slips, trips and falls, like the conditions of commonly used areas such as a well-traveled walking surface, stairway or ladder. People tend to perceive these hazards (and especially human factors) as being a lot less risky than they actually are, which makes it challenging to find effective and permanent solutions.īecause these factors require constant attention, they can be avoided entirely (or made worse) by employees’ mental states throughout the day. The main characteristic the three biggest causes have in common is they’re the result of the errors or errors in judgement that people make every day, like how tidy to keep their work area, whether to report a wet surface or debris that could be a trip hazard, how fast to walk, and whether to move blindly around corners. Use the following checklists to inspect your fall arrest or travel restraint equipment every day.This is an excerpt from our free guide on preventing slips, trips and falls.Ī 2014 survey of 1,294 safety professionals revealed the most frequent factors in slip, trip and fall incidents at their workplaces-and a whopping 95% of respondents cited one of three causes. Fall protection systems are only effective if they are used properly, which includes keeping them in good working condition. Inspecting fall protection gear frequently is as important as using it. Inspect and maintain fall protection equipment regularly Talk to your supervisor to find out what equipment is best to keep you safe. The type of fall protection used depends on the job being performed. Lifelines should be at least 16 mm in diameter and made of strong materials (polypropylene or other strong materials are recommended over nylon, which stretches more). The system usually includes a harness, anchorage support, lifeline and lanyard. Fall arrest: A system that stops workers in mid-fall before they can hit a surface that would cause injury. In general, slips and trips occur due to a loss of traction between the shoe and the walking surface or an inadvertent contact with a fixed or moveable object which may lead to a fall.The system usually includes a harness connected to a lanyard tied off at a set length from a weighted tie-off point. ![]()
0 Comments
Leave a Reply. |